
Decorative flake flooring
Decorative Flake Flooring in Palm Beach, FL
A full flake floor hides dust, tire marks and small flaws in the slab, and adds a light texture underfoot. We broadcast the flake to full coverage, scrape it and seal it under a clear topcoat.
- 224 Datura St ste 740, West Palm Beach
- (443) 501-0540
- Full broadcast
- Your blend
- Clear topcoat
- Free On-Site EstimatesWe measure and price the floor in person.
- Ground, Not Just WashedEvery slab is diamond ground before coating.
- Moisture Checked FirstWe test the slab before choosing the system.
- Open 24 Hours, Mon to FriCall or send the form any time.
Decorative flake flooring
What Is a Decorative Flake Floor?
A decorative flake floor is a coating system with colored vinyl chips broadcast into the base coat. The flake is spread until the base is fully covered, the loose chips are scraped off, and a clear topcoat seals the rest.
It's the finish we put down most in Palm Beach County garages because it's forgiving. The speckled blend hides the fine sand and dust that blow in, tire marks and drips between cleanings, and small flaws in the slab.
You choose the blend. Sand and white blends suit coastal homes, gray and black blends suit newer homes, and we bring samples so you see them in your own garage light.

Picking a blend
How to Choose a Flake Blend
Most blends mix two to four chip colors. Lighter blends hide the pale dust and sand that blow into a Florida garage; darker blends hide tire marks and drips. Mid-tone blends of gray, tan and white hide a bit of both, which is why they're the ones we lay most.
Look at samples in your own garage, with the door open. A blend that looks warm in a showroom can look gray in shade and bright white in afternoon sun.
What helps you decide
- Match the blend to the cabinets and trim, not just the walls.
- Hold samples where the sun actually lands on the floor.
- Pick a mid-tone blend if you want the floor to hide the most.
Full or partial
Full Broadcast or Partial Broadcast?
Flake can cover the floor completely or be scattered over a colored base. The two look and wear differently.
| Full broadcast | Partial broadcast | |
|---|---|---|
| Coverage | Chips cover the base coat completely | Chips are scattered over a visible base color |
| Look | Speckled, like stone | Solid color with flecks |
| Texture | Light texture across the whole floor | Smoother between the chips |
| Hides wear | The most | Less, since the base color shows |
| Where it fits | Everyday garages, laundry rooms, workshops | Shops and rooms where a solid color is the goal |
Most of the flake floors we install in Palm Beach County are full broadcast.
What's included
How Is a Flake Floor Built?
A flake floor takes the same prep as any coating, then three steps that make the finish.
Ground Slab
The concrete is diamond ground and repaired so the base coat bonds.
Base Coat
A pigmented base coat goes down in a color that matches the blend.
Full Broadcast
Flake is thrown into the wet base coat until none of the base shows through.
Scrape and Seal
Loose chips are scraped off and a clear topcoat seals the floor.

How it works
How Does a Flake Floor Get Installed?
From picking a blend to walking on the floor, a flake job runs in four steps.
Step 1: Estimate and Blend
We measure, check the slab and help you pick a chip blend from samples.
Step 2: Grind and Repair
The slab is ground and cracks and pits are filled.
Step 3: Base and Flake
Base coat, full flake broadcast, then the excess is scraped off.
Step 4: Topcoat and Cure
The clear topcoat goes on, and we tell you when it's ready for use.
Flake vs solid
Flake, Solid Color or Metallic?
All three go on a ground slab. They differ in how they look and how much they hide.
Decorative Flake
Hides dust, tire marks and slab flaws. The most forgiving finish for a garage.
Solid Color
A clean, even look that shows dirt more. Common in shops and commercial spaces.
Metallic
A poured, glossy showpiece for rooms people spend time in, not everyday parking.
Cost
What Does a Flake Floor Cost?
Flake floor pricing comes down to the square footage, the condition of the slab and the topcoat. A slab that needs old paint ground off or wide cracks repaired takes more prep before the first coat.
We price every flake floor at a free estimate after we've measured it.
Garage floor coating cost in West Palm BeachWhat moves the price
- Square footage
- Slab repairs
- Old coating removal
- Topcoat choice
Measure Your Floor
Pick a typical garage size or enter your own. We measure exactly at the free estimate.
440square feet
Related services
Other Floors We Coat
Flake is our most-asked-for finish. These are the services that go with it.

Garage Epoxy Floor Installation
The full garage floor system, prep to topcoat.
- Two- and three-car
- UV topcoat

Polyaspartic Floor Coatings
A UV-stable topcoat that keeps the blend from yellowing.
- Won't yellow
- Faster cure

Where we work
Flake Floors Across Palm Beach County
We install flake floors in West Palm Beach and these cities and towns.
Asked often
Decorative Flake Floor Questions
Is a flake floor slippery when wet?
The chips give the surface a light texture, so it has more grip than a smooth coating. A grip additive can go in the topcoat for floors that get wet often, like a garage next to the pool.
Can I pick my own flake colors?
Yes. We bring samples to the estimate. Many Palm Beach County homeowners choose sand and white or gray and black blends.
Does flake hide cracks?
It hides small flaws, but cracks are filled and ground flush before the coating goes down. A crack left under the coating can show through or keep moving.
How do I clean a flake floor?
Sweep or blow out the dust, then mop with water and a mild cleaner. Skip harsh chemicals and abrasive pads, which can dull the topcoat.
Can flake go outside?
Under a roof, like a covered lanai or a screened porch, yes, with a UV-stable topcoat. Fully exposed slabs need a system chosen for sun and rain.
Free on-site estimate
Get a Free Flake Floor Estimate
Tell us where the floor is and roughly how big. We'll bring chip samples to the free estimate.
- Free on-site estimate
- Slab checked for moisture
- Concrete ground before every coating
